Raptor NGM Manuel d'utilisateur télécharger pdf (Page 11)

User Manual

Charging the battery

The new battery will reach the optimal efficiency when it has undergone several continuous complete charges and

discharges. When the battery is low, charge it in time. Over-discharge can damage the battery.

First, remove the USB connector cover. Connect the charger to the AC power supply and to the phone USB

connector. During charging, the battery capacity icon on the screen will report the charging process. After the

battery is full, the battery icon will be full. Cut the connection of the charger with the AC power supply and then

the connection of the charger with the mobile phone.

Note: Slight heat formation during charging is normal.

Warning: when a travel charger and its accessories are used to charge the battery, please check first that they are

original or recognized by the manufacturer. The use of other accessories may damage your mobile phone and

cause risks! Always use them indoor and in dry places.

Warnings on the use of the battery

The performance of the battery is affected by many factors, including network settings, signal strength, work

temperature, chosen and used functions or settings as well as phone accessories, tone, data or other applications.

For optimal performances, please follow the rules below:

 New batteries or a battery unused for a long time need a longer charging time. The standard voltage scope

for the battery is 3.6V-4.2V.

 During charging, keep the battery around room temperature.

 With time passing by, the battery will gradually be worn and thus needs longer time to charge. This is

normal. However, after normal charging, if call duration decreases while charging time increases, you will

need to buy another battery from the original manufacturer or one authorized by the manufacturer. The

battery of lower quality can damage your mobile phone and cause danger!

 If the phone is overused at low battery level, it might need a longer time for the charging indicator to be

shown on the screen.

Note: please dispose the battery according to the local regulations. Try to recycle the battery if possible. Do not

treat the waste battery as common waste.

Warning: do not throw the battery into fire so as to prevent fire hazard. The broken battery may cause explosion.

Warning:

Charging the mobile phone by improper means can cause to explosion. Always refer to the related

regulations for the disposal of the battery.

PIN code

PIN1 Code: it is the personal identification number used to enter SIM and prevents others from using the SIM

without permission. If the mobile phone has activated the PIN1 code protection, when powered on, the screen will

display “Input PIN”. During the process of inserting the PIN1 code, the screen will show “*” to represent the input

content for privacy. You will obtain the PIN1 (and further) code when buying your SIM card.

PIN2 Code: it is the personal identification number used for some special functions.

PUK Code and PUK2 Code (8 digit): to change the locked PIN code, you need to use PUK (Personal Unblocking

Key) code. To change the locked PIN2 code, you need to use PUK2 code. If these two codes are not provided

together with the SIM cards, ask your service provider.

Warning: if you input the wrong PIN code for three times continuously, the SIM card will be locked. Please contact

the network operator immediately for help. Attempts to unlock the code may make the SIM card ineffective

forever!

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 46 47

Pas de commentaire

Raptor NGM Manuel d'utilisateur Page 11